![]() Pictures demonstrating soldering points on the board: Into a charger corrects this issue by forcing the BMS (and controller potentially) to do a state check. This problem occurs because the BMS goes through a state reset and doesn't know the status of the battery, and plugging the board If after installing OWIE into your board it reports that your battery is at 1% even though it shouldn't, plug your board into a charger. I also put a bunch of tape on the top of the board, just in case.ĭONE! Troubleshooting: Board reporting battery at 1% after install
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |